Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Routing *8

Status
Not open for further replies.
drichter12

drichter12

Technical User
Dec 15, 2005
232
US
Is it possible to route all calls that begin with *8 to another system connected via PRI trunks? I am currently using DSCs for several numbers that I am routing to this other system via RLI 21 and would like to do the same with any numbers that match *8XXXXX. The * needs to pass to the other system.




Dale
 
Sort by date Sort by votes
*8 or *anything is not a valid steering code... but if you tried to insert a *anything in the DMI table, it accept it, but whether or not it will be sent out over the PRI, you'll have to test that.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Sah219
  • Question
Add 3ed network group with intergroup switch 81c
Replies
0
Views
83
Sah219
Sah219
SherWat
  • Locked
  • Question
ENTC in LD 80 Results Decipher
Replies
0
Views
93
SherWat
SherWat
phoneswitchnewbie
  • Locked
  • Question
Map extension to outgoing 800 number 1
Replies
6
Views
156
phoneswitchnewbie
phoneswitchnewbie
cable_bunny
  • Locked
  • Question
No ringback tone from 81c PABX from Incoming TELCO CO trunk
Replies
4
Views
140
cable_bunny
cable_bunny
techdgrubbs
  • Locked
  • Question
Cannot out a CDP in LD 87 due to Undef Steering Code error 3
Replies
8
Views
181
techdgrubbs
techdgrubbs

Part and Inventory Search

Sponsor

Back
Top