Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Routes

Status
Not open for further replies.

mack27

Programmer
Oct 23, 2002
64
GB
Hi,

Just have a question we have two routes configured on our system one is an ISDN primary rate and the other is a DPNSS link.
Yet they have no dest assigned i.e routes not used from this I understand that are is no cards programmed up on the switch.
What I want to know is do we have these cards just they haven't been "cnhui"

Thanks

mack
 
You don't need any cards to "program" a route......you only need a card if you want to assign any trunks to it.

You also won't have a dest code assigned to a route if it's inbound only.

Hope this helps,

Dave Strang
 
Ok thanks for that how do you define an incoming route? But if you want to have a route that is duplex you would need to assign it to a trunk correct?

 
Well, not actually. (except if you want to make calls - the same as for an incoming route).
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top