Rolm 9751 database error

[Howardf77]

09:17:19 04-NOV-09

-----------------------------------------------------------------------
-- DISK -- -- ACTIVE MEMORY --
STATUS STATUS SIDE

NODE 1: OK - 2 CPU1

-----------------------------------------------------------------------

ERROR SUMMARY
=============

NODE 1: ACTIVE CPU LACKS DATABASE UPDATES
RECOMMENDATION: LOAD STBY FROM DISK,
SWITCHOVER, THEN LOAD STBY MEM

What command do I use to correct this. I have done this once, but con not remember how to do it.

 

[PERRYPJ]

LOAD STBY 9005.x.xx where x.xx is the release and bind number.
Then type LI STATUS SYSTEM S as many times as necessary until the following appears at the top left
SYSTEM_STATUS=NORMAL.
Then type START WDT S, then type LI STATUS SYSTEM S.
The WDT should be ENABLED, you are now ready to switchover into that side. You may want to wait for a slow period or after hours because this will cause loss of calls that are trying to be setup.
Type SWITCHOVER UNCONDITIONAL MAJOR, the system should switchover and the banner will appear log in and type LI STATUS SYSTEM S. If INDEPENDENT SOFTWARE=YES, type LOAD STBY MEM ALL when the Message STANDBY LOAD SUCCEEDED type LI STATUS SYSTEM S. INDEPENDENT SOFTWARE should be NO.
Then you can check the CNFG_STATUS, should be ready to go

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[Howardf77]

PERRYPJ

Thank you for your help. This worked. Old Rolm systems are hard to let go they just seem to keep working and working

 

[PERRYPJ]

YUP I STILL HAVE 10 OF THEM

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[keyset6]

Same here. We just installed a Mod 10 about a year ago to replace an...8000! I think it's kind of funny reading about some of these VIOP troubles. For example, while on a handset it sounds like a half-duplex speakerphone.