Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
RODAI PARAMETERS
- Thread starter CIF
- Start date
U asked for it (extracted from alex
RODAI Route data initiate
FORMAT
ROU = Route number.
For value, consult parameter description for route data.
TYPE = Type of signalling diagram, i.e. the TL function block that handles the TL unit in the equipment position to use.
For value, consult parameter description for relevant application system, which will be found in a separate AS-binder.
VARI = Signal diagram variations for incoming traffic.
For value, consult parameter description for relevant function block TL, which will be found in a separate AS-binder.
Must be stated if the route is defined for incoming traffic.
VARO = Signal diagram variations for outgoing traffic.
For value, consult parameter description for relevant function block TL, which will be found in a separate AS-binder.
Must be stated if the route is defined for outgoing traffic.
VARC = Signal diagram variations common for incoming and outgoing traffic.
For value, consult parameter description for relevant function block TL, which will be found in a separate AS-binder.
Can be omitted only if the relevant TL function block permits this.
FILTER = Filter category.
States whether filter equipment is connected between tone sender and PABX.
The parameter can assume the following values:
YES Filter equipment connected
NO Filter equipment not connected
If the parameter is omitted the value NO is assumed.
VARI,VARO,and VARC are trunk type dependant and they are also version dependant.
What BC version do u use?
What type of trunk do you have?
the info will enable us to help you more.
don't you have Alex?
Good luck
Experience it, there is no substitute.
RemoveThisJazayeri@kiasagroup.com
RODAI Route data initiate
FORMAT
ROU = Route number.
For value, consult parameter description for route data.
TYPE = Type of signalling diagram, i.e. the TL function block that handles the TL unit in the equipment position to use.
For value, consult parameter description for relevant application system, which will be found in a separate AS-binder.
VARI = Signal diagram variations for incoming traffic.
For value, consult parameter description for relevant function block TL, which will be found in a separate AS-binder.
Must be stated if the route is defined for incoming traffic.
VARO = Signal diagram variations for outgoing traffic.
For value, consult parameter description for relevant function block TL, which will be found in a separate AS-binder.
Must be stated if the route is defined for outgoing traffic.
VARC = Signal diagram variations common for incoming and outgoing traffic.
For value, consult parameter description for relevant function block TL, which will be found in a separate AS-binder.
Can be omitted only if the relevant TL function block permits this.
FILTER = Filter category.
States whether filter equipment is connected between tone sender and PABX.
The parameter can assume the following values:
YES Filter equipment connected
NO Filter equipment not connected
If the parameter is omitted the value NO is assumed.
VARI,VARO,and VARC are trunk type dependant and they are also version dependant.
What BC version do u use?
What type of trunk do you have?
the info will enable us to help you more.
don't you have Alex?
Good luck
Experience it, there is no substitute.
RemoveThisJazayeri@kiasagroup.com
- Thread starter
- #4
- Status
Similar threads
