apologises first of all - havent read manuals yet - just at the slap it on and have a poke stage
i have installed 6.5.1 as a master server. the tape device is a dell ml6000 attached via broadcom fibre switch.
the drives are using the symantec drivers. the robot i have updated to a dell driver - (cant give you version just now )
when i go to properties of the robot inside the console - in the robotic path - i get MISSING_PATH:ADICA019703_LLA
IF I SELECT THE PROPERTIES AND THEN BROWSE i can pick the one option for this and then it is ok
i lose this when i reboot - and doing this fixes it
i am assuming it is the driver or some crappy reg entry
any thoughts - anyone have a ml6000 and check the driver
have a copy of other items but will post seperately and i promise i will start to wade through the books
i have installed 6.5.1 as a master server. the tape device is a dell ml6000 attached via broadcom fibre switch.
the drives are using the symantec drivers. the robot i have updated to a dell driver - (cant give you version just now )
when i go to properties of the robot inside the console - in the robotic path - i get MISSING_PATH:ADICA019703_LLA
IF I SELECT THE PROPERTIES AND THEN BROWSE i can pick the one option for this and then it is ok
i lose this when i reboot - and doing this fixes it
i am assuming it is the driver or some crappy reg entry
any thoughts - anyone have a ml6000 and check the driver
have a copy of other items but will post seperately and i promise i will start to wade through the books