Hi Guys
I carried out an upgrade from release 2 to Release five,
with no issues during the process. I need to do some additional programming before carrying out a factory image.
I have found that when I try to program the button on the
kim module but the data wont assign.
Has anyone had this issue or kmow if there is a patch available since V5 was released.
Thanks in Advance
I carried out an upgrade from release 2 to Release five,
with no issues during the process. I need to do some additional programming before carrying out a factory image.
I have found that when I try to program the button on the
kim module but the data wont assign.
Has anyone had this issue or kmow if there is a patch available since V5 was released.
Thanks in Advance