Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

reverse engineering forms using Designer 6.0

Status
Not open for further replies.

Guest_imported

New member
Jan 1, 1970
0
Hi,

I am new to this forum, so hi everybody! I am a student in a 3 month practising job (Then I finally end my studies!). Now, my question:

The fact is that I need to reverse engineer a hole application but, as we all know, it is not possible to reverse engineer the objects and code in toolbar canvases, as well as menus. So, the question is: is there any tip or trick to get the toolbar's objects (with their code) into the repository? Or is the use of a template for re-generation the only solution (the issue in this is that the code and the objects will not be accesable from repository)?

Thanks in advance
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top