srachmaninoff
IS-IT--Management
Is there a way to return to the auto attendant once a call has been transferred from auto attendant to a mailbox?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Return to the Auto Attendant
- Thread starter srachmaninoff
- Start date
- Status
fireeater
Technical User
- Dec 10, 2008
- 780
when in the mailbox press *
this should bring you back to the aa
HALLOWED ARE THE ORI
mike
this should bring you back to the aa
HALLOWED ARE THE ORI
mike
- Thread starter
- #3
srachmaninoff
IS-IT--Management
Pressing the * key is not working.
- Thread starter
- #5
srachmaninoff
IS-IT--Management
Return to auto attendant" is checked, but when I press * it goes into "mailbox options" for the extension I was transferred to.
curlycord
Programmer
Is this Call Pilot set to CP mode or NVM mode?
You can set the system to theses modes or a specific user, check both (user would be in COS)
CP mode is more for those use to the PBX system where NVM is for Norstar users.
I am not so sure of the code to bounce out in CP mode if it's even allowed.
=----(((((((((()----=
curlycord
You can set the system to theses modes or a specific user, check both (user would be in COS)
CP mode is more for those use to the PBX system where NVM is for Norstar users.
I am not so sure of the code to bounce out in CP mode if it's even allowed.
=----(((((((((()----=
curlycord
- Status
Similar threads
- Locked
- Question
- Locked
- Question