I have a BCM 4.0 with a straight T1. All has been well until last week when , if you called any number at the site, you would get dial tone back in your ear. You can not do anything with the dial tone you get back. They could make outgoing calls ok over the T1. I tried to disable/enablew the T1, do a warm reset on the BCM. The only way I got it fixed was a power re-cycle. This was last Thursday and now today it is doing the same thing again. Any one ran into this? Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Westi on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Return Dial Tone when calling BCM T1
- Thread starter jlk53
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
