restriction access code

[mohd911]

hi all,
i have cs1000e ,and i used one PRI trunk to connect our switch to PSTN network
i used this pri(30- channels) to carry out the external call (local ,national ,international) in the same time
i configured all thing route list and access code to access this route to make external calls
and i used TGAR in extension level to permit for the extension to access this route>

my question NOW >>>
when i give the extension permition to used this route this extention can make all type of call (local ,national ,international)
can i separate this type of call example::
ext :515 can dial ((local only)
ext:512 can dial (local ,national only)
ext:513 can dial (international only)

 

[Firebird Scrambler]

Each extension will need a different NCOS assigned to define what calls can be made out.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.com

linkedin

 

[mohd911]

dear firebirdScrambler
I need to know how can i built the relation between NCOS and the call type

 

[Firebird Scrambler]

I would follow the instructions contained in the attached zip guide word doc and use the current *.xlsm conversion utility tool to obtain a current snapshot of all your systems TNB. This will contain the NCOS table used against each extension and if the CLS = TLD etc.

On a different note, post your systems NCOS tables found in LD 49.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.com

linkedin

 

[mohd911]

my brother FirebirdScrambler
thanks you for your support it is done perfectly.
many thanks

 

[KCFLHRC]

If you direct trunk access then NCOS is worthless. NCOS is for BARS