Restrict outbound calling to one area code. 1

[DJPlaZma]

I have 12 analog ports on my system that are used for outbound calling from an analog device. I need to restrict those 12 ports to be able to dial the local area code (616) only. I've set up a unique COR and made the Calling Party Restriction as both TAC-TOLL and ALL-TOLL and tried to narrow the area code down in UCL, but I still seem to be able to make calls anywhere. I think I'm missing a step, but I'm in a time crunch. I've attached a screenshot of the COR.

CM4.1

Many thanks, in advance, for assistance.

-DJ PlaZma
Single-Handedly Keeping the 80s Alive!

http://www.PlaZmaRadio.com

 

[Ronster]

Change toll 616.

                  Total       Toll  CDR   <--unrestricted call list-->
Dialed String   Min Max  RCL  List  FEAC  1  2  3  4  5  6  7  8  9  10
616             3   9?         x                x

Setup a COR with the "Calling Party Restriction" set to all-toll
Then add the relevant unrestricted call list to the COR.

The Max would be set to the usual length of the full numbers. In the example above I used UCL 3 but it can be any free UCL.


_______________________________________________________________
A cucumber should be well sliced, and dressed with pepper and vinegar, and then thrown out, as good for nothing. SAMUEL JOHNSON (1709-1784)