When upgrading from 4.2 (10.2.0.26_2) to 5.0 SP1 PR1(11.0.1.26)the upgrade whet OK Licensing went OK but most of the way through the restore I recieved the following while monitoring the RTC port. The data restore seemed to finish and the phones came up but when logging in I recieved the same message via a popup.
*** DATABASE RESTORE FAILURE ***
A database restore hasn't completed successfully.
You must perform a database restore again.
If the database restore continues to fail with the same
back-up file, then you must find a different backup and try again.
I tried a different database same issue and had to put it back to 4.2 which went well. I spoke to Mitel who had the same issue as I did during his testing and is taking it up a level. has anyone had a similar issue?
Craig
*** DATABASE RESTORE FAILURE ***
A database restore hasn't completed successfully.
You must perform a database restore again.
If the database restore continues to fail with the same
back-up file, then you must find a different backup and try again.
I tried a different database same issue and had to put it back to 4.2 which went well. I spoke to Mitel who had the same issue as I did during his testing and is taking it up a level. has anyone had a similar issue?
Craig