Resetting Y or N? 1

[DaveThePhoneDoctor]

Reinstalling a MICS that was in storage for a lone time.

KSU and NAM are working ok. Sets seem tobe ok. Can notdial out with 9 right now.

Wondering if as a rule I should always reset a new install back to factory settings. Will this be easier on me.

What are factory settings defaulted to for example?

On site now could use some help or a big cup of coffee cause it is going to be along night.



Dave,
The Phone Doctor
Las Vegas, NV USA

"You're Never Alone When You're Near A Phone!"

...Lily Tomlin
a/k/a "Ernestine

 

[hawks]

Make 9 the access code for pool A and put the lines into pool A. And yes I would do a Sytem Startup and take the switch back to default.

 

[DaveThePhoneDoctor]

Looks like I was programming the wrong loop trunk ports. The number of the ports was not logical ( to me anyway ). I thought it would just start off 001 thru XXX

Dave,
The Phone Doctor
Las Vegas, NV USA

"You're Never Alone When You're Near A Phone!"

...Lily Tomlin
a/k/a "Ernestine

 

[DaveThePhoneDoctor]

What is the proceure for resetting the MICS and NAM back to factory deafult. And then what will the factory default settings be?

Dave,
The Phone Doctor
Las Vegas, NV USA

"You're Never Alone When You're Near A Phone!"

...Lily Tomlin
a/k/a "Ernestine