Gents:
I am running Fedora 14 with a USB attached HP P2035 laser and I have the HPLIP drivers installed and printing is via CUPS.
Two issues:
1) all of a sudden all my pages are printing 2-up. I've tried going through system/admin/printer as well as cups admin with no success.
In the HP Device Manager program there is a setting under Printer Settings that has a section for N+ pages... There is a setting for 1-up but it doesn't work. So, is there and what is the best way to set the n-up value to default to 1?
2) on the same printer I'd like to reset the default margins to .50 versus the default of .19 which causes clipping to occur on the edges. Again, I've look everywhere with no luck.
Thanks for any pointers, directions anyone can provide.
I am running Fedora 14 with a USB attached HP P2035 laser and I have the HPLIP drivers installed and printing is via CUPS.
Two issues:
1) all of a sudden all my pages are printing 2-up. I've tried going through system/admin/printer as well as cups admin with no success.
In the HP Device Manager program there is a setting under Printer Settings that has a section for N+ pages... There is a setting for 1-up but it doesn't work. So, is there and what is the best way to set the n-up value to default to 1?
2) on the same printer I'd like to reset the default margins to .50 versus the default of .19 which causes clipping to occur on the edges. Again, I've look everywhere with no luck.
Thanks for any pointers, directions anyone can provide.