Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Resetting to factory defaults

Status
Not open for further replies.
topdabadawg

topdabadawg

MIS
Jan 7, 2011
66
US
I have a 6509 chassis with redundant supervisor modules #WS-X6K-SUP2-2GE. My secondary module has lost its mind and just keeps cycling, unable to boot. I cannot console into the console port to alter anything and cannot break the sequence. The reset switch just cycles it through to the loop again. Is there a way (in hardware) to reset this thing?

Jim Rapier
"Money can't buy happiness, but it can buy a big ass boat and you can sail right up to it." - Johnny Depp
 
Status
Not open for further replies.

Similar threads

JMarine0811
  • Locked
  • Question
CISCO VG450 Factory reset
Replies
1
Views
425
whykap
whykap
Luzbel
  • Locked
  • Question
Connecting HVAC controller to network
Replies
0
Views
255
Luzbel
Luzbel
Skip Rango
  • Locked
  • Question
how to backup cisco sg500-52p switch
Replies
1
Views
346
madwok
madwok
PThomp3344
  • Locked
  • Question
Trying to connect to Cisco Unified Controller web interface: UC520W-16U-4FXO-K9
Replies
1
Views
300
bdk76
bdk76
WinstonCH
  • Locked
  • Helpful tip
What is wrong with the diagram, there are people who will help to fix it? How do i do the configurat 1
Replies
1
Views
482
BIS
BIS

Part and Inventory Search

Sponsor

Back
Top