Reseting a VOIP phone in remote location

[mokeefe69]

Is it possible to reset a VOIP phone in a remote location thru the sig serv or thru the pbx? If so, what is the command?
Thanks in advance

 

[bigindian65]

ld 117
as long as the set is registered.

RST DN - Reset IP sets with specified DN

Mato' Was'aka

 

[curtismo]

Another thing I had had to do (if the phone isn't registered) is to use the PoE switch commands (in my case, with the Nortel 5520) to turn off the power on the port, then turn it back on.

conf t
interface fastEthernet <portnum>
poe poe-shutdown
no poe-shutdown
^Z

 

[Aaith]

if you can get to the Sig server / call server where it is registered. you can preform a isetReset
dont do a isetResetAll unless you want all phones to reset XD

(if you have multiple sig servers and call servers you will have to check which server its on first)

Log into the sig server.
and type isetShow (case sensitive)
you will see all sets registed to that sig.

then you can just isetReset

all the iset commands are


oam> help iset
iset
iset module commands:

isetShow Show general information for all registered sets
isetFWShow Show general information about firmware of all registered sets
isetNATShow Show information about registered sets behind a NAT router
isetShowByTN Show general information for all registered sets, sorted by TN
isetShowByIP Show general information for all registered sets, sorted by IP
isetLocShow Show location information for all connected sets or specified set
isetLocNeedUpdateShow Show location information for connected sets that need a location update
isetLocNeedUpdateShow_DMShow location information for connected sets that need a location update
isetLocUpdate Update location information for specified set
isetReset Reset registered IP set
isetResetAll Reset all registered IP sets
isetCount Show total number of registered sets
isetGet Show a list of IP phones based on a given query
isetFWGet Show a list of IP phones firmwares based on a given query
itgPLThreshold Set the i2004 and gateway alarm packet loss threshold (units .1%)
nodePwdSet Set password for current node
nodePwdShow Show node password setting
nodePwdEnable Enable node password setting
nodePwdDisable Disable node password setting
nodeTempPwdSet Set a temporary password for current node
nodeTempPwdClear Clear the temporary password for current node
clearLockout Clear Branch User Config lockout
dsetDelayHookswitchSet Configure maximum value of time period in msec during which set waits for the hookswitchRequest
cookieShowByTN Print the cookie list for a set specified by TN
cookieShowByName Print the list of sets with a particular cookie set
cookieRegShow Print the cookie registry