reset to the default

[Engnrzubair]

thread799-1460251 i have the same problem that i have MICS system but i cannot log in the system to do any kind of programming How can i reset the system to its default bcs i don't have any kind of passwords i forgot the password of the system please help my guys

 

[norstarboy125]

I believe I said this before but here it goes again. If you don't have the CONFIG-xxxxxx pswd then you have two choices.


1- Perform the DEBUG procedure which can be kinda tricky to the average Joe.


2- Take the Norstar system apart and short the battery. This will default the system and require reprogramming of entire system.

Charm City Communications

http://www.charmcitycommunications.com

 

[Multimedium]

If your system is equipped with an expansion cartridge, you also have a third choice: downgrade the system.
[ol 1]
[li]Power down.[/li]
[li]Remove the expansion cartridge.[/li]
[li]Power up.[/li]
[li]The alarm set prompts for a cold restart. Accept. The system restarts and the programming defaults.[/li]
[li]Power down.[/li]
[li]Reinstall the expansion cartridge.[/li]
[li]Power up.[/li]
[/ol]

 

[allworxguy]

If no expansion card, power down, put one in, power up, wait for time and date, power down, remove expansion and reboot.

Shorting the Capacitor:
You run the risk of damaging the capacitor by shorting it's leads and/or shortening its life expectancy. Not recommended.

Marv ccna

http://www.telemarv.ca

Sales, Installation & Service for Norstar, BCM & Allworx
Serving Ottawa and Eastern Ontario since 1990