Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reset to Default

Status
Not open for further replies.

pingableinc

IS-IT--Management
Feb 20, 2007
24
US
IPO running 3.55

Reset to default under Manager.
It went into DHCP mode. Found it and have attempted to log in....via default pw of Administrator / Administrator.

It's not taking it. Any advise..just short of DTE.
 
I assume this is a 3.2.55 system -

You need to reset the security information, which is no longer held in the configuration
avaya knowledgebase said:
1. Attach the serial cable between the PC and the DTE port on the IP Office control unit.
2. Start the terminal program on your PC. Ensure that it has been setup as listed in DTE Port Settings. Within a HyperTerminal session, the current settings are summarized across the base of the screen.
3. Enter AT (note upper case). The control unit should respond OK.
4. Enter AT-SECURITYRESETALL.
5. You will be prompted to confirm the control unit's MAC address before continuing. Enter the address.
6. The control unit will respond OK when the action has been completed.
7. Close the terminal program session.
8. Manager can now be used to receive and edit the control unit's now defaulted security settings.




Take Care

Matt
If at first you don't succeed, skydiving is not for you.
 
why reset it ?
just login as you are used to do
when you default the ipo the security settings stay the same


ACA - Implement IP Office
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top