Reset login on s8300 1

[cathyd]

I was remotely working on a new 8300 when my laptop inexplicably rebooted. When I went back in and tried to change the vector I was working on, it told me my login had the data locked. I logged off, disconnected and went back in again and had the same problem. I then went in as dadmin and disabled my login, but that didn't work. I tried to remove it, but it said object was busy.

Does anyone have any suggestions?

Thanks.

 

[petran]

Login to the S8300 as dadmin and type "status logins"
You will see all logins that are currently logged-in to the system and the command they are running.

Find the login that you were using when your laptop rebooted and check the number at the column at the right part of the screen.

Then type "reset login x" where x is that number. This will force a logoff of the login that has the problem.

Petran.

 

[cathyd]

Thank you so much!!

Have a great day,

Cathy

 

[longhuhu]

only commond "reset login x" then ok.