Rescueing of ELU-31 Base stations

[doktor]

Rescueing of ELU-31 Base stations, that stopped working after a firmware upgrade?
How to get a few BS330-9001 R4B to work again after a failed firmware download. The units are now left with no software but the boot sw still exists. No communication is possible with the base stations.
Are there some tricks to get them to work again.



///doktor
____________________________________

http://www.kandu.dk/spg153996.aspx

 

[xs650]

Did you find a solution for this problem?
I have the same problem with a BS330 where the software upgrade fails.
Did you maybe have tried the base station manager?

 

[INLSP04]

hi
doktor can work with air solder????

 

[doktor]

Base station Manager should be able to handle this. I have not yet tried...

///doktor
____________________________________

http://www.kandu.dk/spg153996.aspx

 

[fcpli]

Doktor,

What happens here, is that with BSM you'll not get a connection to the BS, it shows some strange info (tried it without success). All FW for the BS is an add-on (or similar), so the SW needs to be there before updating. One way might be to copy a very old SW from a working BS and to insert it in the faulty one (the chip), then starting from scratch. Or check with the manufacturer (Ascom), what to do.

fcpli