Reroute calls towards IP Gateway (One more Try) Help...

[PhoneGuyy]

Hi all - having a bit of a time figuring out how to configure ESN to re-route PSTN calls to DID numbers at other sites over our PRI trunks pointing to a gateway. Our users are creatures of habit and/or have speed dial numbers set up for colleagues DID numbers at other offices. So I'm wanting to configure ESN to look for 9-1-907-555-1234 for example, and DMI it to 9-555-1234 and route it out the PRI trunk route to the gateway. The issue that I am having is that I know I can create a SPN and put in one Alternate DN but can I insert a range? or is there any other thoughts to this under SDRR/DID...

 

[PERRYPJ]

Use DSC in LD 87

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[bignose21]

I'd do it as ARRN's against your SPN. So say you have an SPN of 1907 and you wanted the 555 1xxx range it would be a sigle ARRN 5551 Route it using your ARLI and delete 4 insert 9

 

[PhoneGuyy]

What is I wanted the whole block say the other campus has the block 235-16xx, can I just put 23516 in the ARRN and it will take the xx part as a wild card? I am assuming yes...

 

[Spokes0831]

I am doing something similar at my workplace. I am sending DID's from a Nortel Switch to a Cisco Gateway. Basically, I set up a CDP the last 4 digits of the DID and ship that over the pipe built for Cisco. That can be accomplished in LD-87. I would take that 1234 of the number you provided and build a new RLI and point it at the gateway. Hope this helps.

 

[PhoneGuyy]

Yea I cant do it that way...
I am not sending DID per say I am sending just certain numbers out of certain NXX's....

So for example...
1.907.235.1600-1699 are all extensions at another campus...

Well that same 1620 is a directory number at my campus...

 

[bignose21]

So in that example SPN 1907 is sent out as Delete 4 type NXX and you could use an LDID 2351620