A report developed in CR 8.5 with a left marfin setting of 0.00 (needed for placement of OMC scan mark on far left edge)is printing with a left margin of 1/8 inch from both Crystal and the delphi based report generator. The margin appears correctly in report view. Any suggestions for getting this report to print with the specified margin?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Report printing with incorrect margin setting....
- Thread starter sylvias
- Start date
Take a look at [Printer Setup] under the [File] menu. Is its version of Paper Size the same as the paper you are actually printing to?
If it is, then maybe pretend that you are using a larger paper size and get it printing on the edge by trial-and-error.
Crystal is notorious for looking different on the printer than it looked on the screen, and often different on different printers.
Madawc Williams
East Anglia, Great Britain
If it is, then maybe pretend that you are using a larger paper size and get it printing on the edge by trial-and-error.
Crystal is notorious for looking different on the printer than it looked on the screen, and often different on different printers.
Madawc Williams
East Anglia, Great Britain
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Question
- Locked
- Question