I know this sounds basic, but I can't figure it out. I used the report wizard to create a report, and it's orientation was set to portrait. Now, I would like to change it to landscape, but I cannot find anywhere in the properties this attribute is set. When I print the report, I can change it at that time, but then the change doesn't become perminent. Is there any way to perminently change the orientation?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Report Orientation
- Thread starter dejfatman
- Start date
mdthornton
Programmer
Yep, just go into page set up in the report design view. You can set orientation, page size, margins etc in here. Best Regards,
Mike
Mike
- Status
Similar threads
- Locked
- Question
