Report Margins Resetting Problem

[Sech]

I have a database in Access 2000 which prints out a number of reports. When I go to change the margins of the reports as it is no longer fitting on a single page, it appears to save correctly. However when I then go back into the database the margins are reset back to what they were. Even stranger is that on my PC the right margin says 12.77mm, but when I try installing the database on a customers PC, the right margin is 14.89mm. I have checked previous forum threads on this issue, and ensured that "Track name AutoCorrect info" is unticked in the options. I cannot install the Office 2000 service pack SR 1/1 as my PC is on a network. Is this the only way that this problem can be fixed?

 

[pdldavis]

Hi, one thing that works sometimes is go to design view, move a couple controls around, move them back, save the report & reset your report margins.

That might help.

 

[BobJacksonNCI]

Sech,

I think this problem was addressed in Access 2003. (Resolved?)

There is quite a bit of code shown in Thread702-560490, but you don't have to change it.



HTH,
Bob