I have set up a report which takes data from an Iseries/As400.
However there are two separate installations of an application on the Iseries/As400 in different locations.
I would like to use the same report definition for both locations.
Is it possible to make selection of a shared connection parameter driven for a report?
Otherwise I suppose I would have to do a stored procedure on the Iseries/As400 and pass it a parameter indicating which location to get the data from.
Dazed and confused.
Remember.. 'Depression is just anger without enthusiasum'.
However there are two separate installations of an application on the Iseries/As400 in different locations.
I would like to use the same report definition for both locations.
Is it possible to make selection of a shared connection parameter driven for a report?
Otherwise I suppose I would have to do a stored procedure on the Iseries/As400 and pass it a parameter indicating which location to get the data from.
Dazed and confused.
Remember.. 'Depression is just anger without enthusiasum'.