We have a call Pilot 200i (old)1.7 software. We have been told to replace the old 200i card with a new (refurb) 200i card since the SCSI connector/port does not work anymore. We have tested all the equipment and this is going to be our fix. My question is, once I get the new card can I just take the existing hard drive off the old 200i and put it on the new 201i? Is there any imaging that has to take place? Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Replacing Call Pilot 200i
- Thread starter BCR840
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
