Replacement of PU5DC

[tomd110]

In our 3 lim system (BC9) the PU5DC power card (ROF1375350/1R2B) broke down and therefore i ordered a new one.

The new one is a RG5DC (ROF1375350/2R3D) with dip switches on it.

Can i replace it without problems and how do i set the switches for the austrian market - as default all are open

cheers ...

 

[MDfreak]

Hello
you can install RG%DC on each MAG of your system unless you have REU in that MAG.
for doing that you need to do the following:
1- change the switches to this position the 1st one to right and the last one to right, don't change the others.
2- power off your MD110 and replace each PU5DC with RG5DC
which doesn't conatin the output power to REU unit the provide analog extensions with ring voltage, so all you need is the input to the RG5DC coming from - 48 volt.
3- remove REU's and it's done.
5- power on your system and relax till it load completely.