replace disa card

[curt2k]

have a mics w/3.0 rel 2-12x0 cab,2-0x16 cab.on 2nd 12x0 on card 2(L065,066,067,068)it now has a disa card w/em programmed for lines.i disable and remove card.install ls/ds card enable it and try to make it loop start.but it stays e&m.can someone tell me how to make these lines loop start again.
thanks in advance.

 

[exsmogger]

Disable the slot in Maintenance, go to Hardware and change the E&M card to Loop, go back to Maintenance and enable the slot. It may take the system a few minutes to reconfigure the slot for LS trunks.

Brian Cox

http://www.jandjcommunications.com