Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Replace 0x16

Status
Not open for further replies.
Jan 15, 2014
19
US
I have to replace a faulty 0x16 station module - used with 0x32. My goal is to keep the same DN's/extensions.

I'm somewhat familiar with programming the MICS, but have never changed out a station module.

I'd appreciate any guidance.

Thank you
 
I believe if you disable the module you can then replace it without turning the system off, then enable it, the extensions should be the same. I don't have my manual with me or a MICS I can access but I believe under Hardware you should be able to disable. Maintenance would be the other place I would check if it's not under Hardware
 
Should be plug and play.
You don't need to power down KSU to swap a station module.
If Set relocation is on then the set will get its DN back however if its off then all will remain the same anyway since sets are still on the same ports.



=----(((((((((()----=
curlycord

small-logo-sig.png

Toronto Canada
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top