Hello, I need to remove unused E1 PRI card from CS1000 PBX. As I understand we have to
Out Trunk with LD 14
Out RDB with LD 16
Out DCH with LD 17
Out Loop with LD 17
Please lets me know if the step are correct. Thank you in advance.
so it depends if its the only one in the route and if its a clock source
LD 96 - disable DCH and MSDL
LD - 60 disable PRI and Clock controller (if its the only reference on the CC or has the CC card installed on it)
LD 73 - remove the clock config from SYTI (if there is any)
LD 14 - out the channels
LD 16 - Out the route
LD 17 - out the DCH and remove the PRI from the CEQU
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.