BBecker100
Programmer
When I start an application on a WinCE 6.0 x86 via the Microsoft Smart Device Connectivity RemoteProcess Start command, the OS seems to retain almost all of the memory as In Use, after the Application exits. If I start the same application from the command line on the device and then exit it, the In Use amount goes back almost to the same point it was at before starting the executable. (Looking at the Control Panel -> System Properties -> Memory)
After Remote starting and stopping a number of times, the OS will complain that it is out of memory and then I have to Reboot in order to get rid of the Out of memory message on the console.
This behavior is different than on WinCE 5.0 (Never saw this error).
After Remote starting and stopping a number of times, the OS will complain that it is out of memory and then I have to Reboot in order to get rid of the Out of memory message on the console.
This behavior is different than on WinCE 5.0 (Never saw this error).