I need to remotely power down and then up an Octel 200. I do have someone onsite who will be able to hit the power switch but they won't be able to log into the system. If I log in remotely and do the "SHUTDOWN" command on the Octel, how will the system start running again later? I won't be able to log in to run the "STARTUP" command. Would I be better off just forgetting the shutdown command and having them hit the power switch to turn it off?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Remotely power down/up Octel 200
- Thread starter KFLORIDA
- Start date
@RESTA will just restart the OCTEL.
I would recommend that you check the hard disks before by @DEX 1 (printout should show 000000 in all fields), and get some one to switch off the system, wait for 3 minutes and turn it on again.
What is the purpose of this?
A @RESTA will do the job in most cases.
///doktor
I would recommend that you check the hard disks before by @DEX 1 (printout should show 000000 in all fields), and get some one to switch off the system, wait for 3 minutes and turn it on again.
What is the purpose of this?
A @RESTA will do the job in most cases.
///doktor
- Thread starter
- #3
Our location is getting a new generator. We will be powering off Friday night and leaving everything off for about 24 hours. Once generator is in and all power cords moved over, we will turn everything back on. Should I skip the shutdown command? Can I run the DEX 1 command ahead of time? Thank you, Kimberly
- Status
Similar threads
- Locked
- Question