Remote site ringing.

[RYLSFAN]

I have 2 switches that are networked together ( A and B)

The only outside lines are through site A.

B presses 9 to get out through site A, my remote access package works greaet.

Here's my question. How can i get target lines to point to IP phones on the BCM50 at site B that ring in on the DTM at site A? I want all incoming calls to point to phones on a different switch?

Thoughts on how to accomplish this?

TIA

Thats not my fastball, thats my hurry up and get by you pitch... Satchel Paige

 

[cook1082]

Build a route and dest code in site A for the remote DID's in B,then in the gateway enter the destination digits. It should ring B now if the target lines are programed on B.