Remote programming problems

[MasterCommDave]

I am dialing into a BCM to to some programming. This system needs the :6800 to connect. The unified manager connects and the screen says Enterprise Edge, These is an icon that says configure. The system then loads Java but the screen I get is blank. I am on XP professional. Is there a step I am missing or Compatability issue?

 

[MagnaRGP]

Java 1.5 or lower. Also ensure pop-ups are enabled on the PC for the BCM IP address.

 

[MasterCommDave]

I have checked all of that, I even went back to Java 1.4. No luck. I turned off pop ups through windows and Norton antivirus. Any thinig else I am Missing?

 

[MagnaRGP]

How old is the BCM? Hasn't been called Enterprise Edge for a looooooong time. Maybe you need to downgrade Java even further to 1.3? Maybe use MS Virtual Machine.

 

[acewarlock]

You need to turn popus ON

 

[MasterCommDave]

Thanks all for your input, I did go back to MS Virtual Machine and have successfully done programming. I would like to know if anyone why the dial up connection is 14.4 when the modem is supposed to support 56k. Is there somewhere this gets turned on? Thanks again.

 

[acewarlock]

Speed is adjusted for line conditions.