Remote programming GDK186 1

[joehawkins]

Hi

Can anyone tell me exactly what i need to access the switch remotely, ie: software package etc?

Many thanks

Joe

 

[doktor]

You need a MODU in the GDK-186, and some programming.
At your remote center you need an analog modem and a PC that can rum the GDK ADMIN program.
It is bes to use the newest s/w for the GDk-186. like:
GS86P-E.5GZ.
The build-in modem (MODU) is a daughter board for the
MBU. the MODU is to be installed on connector: CONN5 (CN5).
The station number is per default the last number in the PBX.The MODU runs 2400 baud, 8 data bits, no paritet, 1 stop bit.



///doktor

 

[joehawkins]

Thanks doktor any ideas where i can pick up the software?

Many thanks again

Joe

 

[doktor]

The GDK ADMIN program is found here:

http://www.lg-nortel.es/lgnortel/areatecnica/softwaregdk/index.html

The firmware for the GDK-186 is to be put into 4 EPROMs.
This s/w you must obtain from your local LG-Nortel dealer.

You also need the MODU board.

///doktor

 

[doktor]

The last number on the GDK-186 will be ext# 285.
the maximum number of stations/extensions is 186 (from 100 to 285). The trick is to make an ISDN/DDI number point to ext# 285 by means of PGM05, or through an analog line in PGM32.

///doktor

 

[joehawkins]

Thanks doktor

i have downloaded this GDK-ADMIN A.0CI CORRECTO but it won't install it wont get past the setup wizard, is this the correct one?

Thanks

Joe

 

[doktor]

What Windows operating system do you use?

///doktor

 

[joehawkins]

Windows XP Pro

Thanks

Joe

 

[doktor]

I had the same kind of problem on XP pro, and found my old Windows 2000 laptop. On this PC the GDK admin worked OK, and now I just that PC for remote servicing of GDK's.

///doktor