Remote Agents and VXA-2 Autoloader

[sergeys]

Backup Exec 9.1 was running on an old server. It backed up several 2003 servers via Remote Agents.
I wanted to move Backup Exec to a newer server. Downloaded a copy from Veritas, installed it using the same serial number, as my old copy. Took my old server down.
Then, I went to setup a backup selection, and I can't select my servers with remote agents. Do I have to do something else to those remote agents?

Also, VXA-2 1/10 autoloader was attached to the old server. I attached it to the new server. Did not install Exabyte driver. (I thought Backup Exec will install its own driver) Backup Exec installed a VXA-2 driver, but did not install an autoloader driver. (in my old server there are two drivers in device manager - VXA-2 driver and autoloader driver). In Backup Exec I do not see an autoloader. It is displayed as a standalone drive.
Thank you in advance.

 

[sergeys]

Autoloader appeared in Backup Exec after installing Backup Exec service pack 5.

 

[sergeys]

Backup agents were not recognized because there were no appropriate licenses (serial numbers) installed on the media server. When I installed Backup Exec on the server, I only gave it the main serial number, needed to install the software. Later I found more serial numbers (one for Exchange agent, and one for server agent) and added those too. After I added those, I could select data on servers running remote agents.