Remote Acess on PRI DID

[TelecomAvatar]

Just wondered if there is any way on a Legend/Magix system to have direct remote access via a DID#. Their are no analog trunks on these systems at all, only PRI for inbound and outbound calls.

 

[TouchToneTommy]

Renumber your remote access code to one of your DID numbers. Then set up STRONG Barrier Codes, change them often, and only give them to those that need them.

 

[HiDesert]

if the T1 ckt is down...how will you RA???? thats why it
is suggested to have a couple of copper lines in the system.

 

[TelecomAvatar]

Where do you renumber the remote access code? Is it under system renumber?

 

[merlinman]

Yes, after you select System Renumber and the Single, it is right there.