Remote access

[Chuc]

My problem is that remote client can ping only the ras server. The ras server assign addresses from the same subnet used in the local network. How can I use the ras server as a router to reach the computers in the local natwork?
Thanks

 

[Hokey]

Start Routing and Remote Access in Administrative Tools

Right-click the server name, and then click Properties

On the IP tab, make sure the "Enable IP Routing" check box is checked.

If this setting is cleared, then the remote clients can only access the RAS server. Enabling it allows them to access the entire network.

 

[Chuc]

Thank you for your answer. IP routing on the RAS server is enabled, and in NetBEUI tab is enabled the access to entire network. Any other idea?