Can anyone help with this prob. Trying to connectto a pc remotely using netmeeting. I am going through a cisco 2514 router with nat. I know to remotely control a pc through netmeeting you have to type the computer name or ip address.In this scenario I have one valid ip address through a cisco router. My internal lan uses unroutable 192.x.x.x address. Any ideas out there???
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
remote access w/netmeeting thru a router
- Thread starter raaudia4
- Start date
Saeed42
ISP
- Jul 4, 2001
- 147
- 0
- 0
You can use PAT by statically mapping anything that comes in for that port to the box you want to connect to (192.168.xx.xx)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Don't be content with being average. Average is as close to the bottom as it is to the top
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Don't be content with being average. Average is as close to the bottom as it is to the top
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Set a static nat entry for your external address, port 389 to the 192.168.x.x address, port 389. (Netmeeting uses 389 if you hadn't guessed already)
set ip nat inside/outside source static...
-Jeff ----------------------------------------
Wassabi Pop Tarts! Write Kellogs today!
set ip nat inside/outside source static...
-Jeff ----------------------------------------
Wassabi Pop Tarts! Write Kellogs today!
- Status
Similar threads
- Locked
- Helpful tip
- Locked
- Question