Remote Access VPN configuration

[SoonTObe]

Hello everyone i just want to give my share of thanks for the helpful tips. i got my pix 501 up and running and it seems to be working just fine to this point. however, i do need help on setting remote access vpn. i found a copy of "configuring remote access access VPNs" i was following the steps until i got to the tunnel-group command. it looks like my pix with the 6.2(1) version, does not have the tunnel-group command. i need to know which command do i use instead. this is the steps i was following:

hostname(config)# isakmp policy 1 authentication pre-share
hostname(config)# isakmp policy 1 encryption 3des
hostname(config)# isakmp policy 1 hash sha
hostname(config)# isakmp policy 1 group 2
hostname(config)# isakmp policy 1 lifetime 43200
hostname(config)# isakmp enable outside
hostname(config)# ip local pool testpool 192.168.0.10-192.168.0.15
hostname(config)# username testuser password 12345678
hostname(config)# crypto ipsec transform set FirstSet esp-3des esp-md5-hmac
hostname(config)# tunnel-group testgroup type ipsec-ra
hostname(config)# tunnel-group testgroup general-attributes
hostname(config-general)# address-pool testpool
hostname(config)# tunnel-group testgroup ipsec-attributes
hostname(config-ipsec)# pre-shared-key 44kkaol59636jnfx
hostname(config)# crypto dynamic-map dyn1 1 set transform-set FirstSet
thanks again...!