Remote Access to G-450

[leosayer]

Gents,

I have a S8500 with G450 setup, basic stuff with 50 users. Problems with Voice quality, suspect it is LAN, but asked to check our end.

2 Questions.

1) I can dial into the USB modem, hook up to the S8500 with no problem. Only things I can see is that the call control settings on the Diff serv values is 26 rather than 46. Also call control proirity is 3 rather than matching the audio (5). Do you think I should change these to match 46,6 and will this effcet anything else. Don't want to make issue worse.

2) Wanted to check the G-450 settings, but how do I access it via modem. On attempting to telnet from orgiginal link to modem, only reach CM. Via go-shell then telent to G-450, get refused. Looked in doc's and searched FAQ etc with no clear answer. Site miles away so cannot really tavel there

Any advice would be much apprecaited.

Thanks in advance

 

[bernycat]

answer question 2?
maybe this...
go shell
ssh root@xxx.xxx.xxx.xxx (IP-adress of G450)

 

[colby007]

Try enabling telnet from the web browser that could do the trick.

 

[leosayer]

Gents

the ssh root@xxx.xxx.xxx.xxx did the trick.

Telnet was enabled.

Great, thanks for that.

Anyone any ideas on questions 1?

All thoughts are welcomed and apreciated

 

[colby007]

In the G700 the QOS settings are taken from the IP network reigon. I assume the G450 is the same however I've yet to dial into one. Do you have QOS on your network?