Release trunk

[trond456]

Hi All,
I have an analogue trunk is programmed as a private line on a certain function key of a digital set, the case is after taking this analogue trunk by pressing this key and release the call then the trunk will be in the busy state for about 20 seconds, then it released? is there any advice to release this trunk after finishing the call directly.

ROCAI:ROU=1,SEL=0110000001000010,TRM=4,SERV=3110000000,SIG=411100000000,TRAF=00151515;

RODAI:ROU=1,TYPE=TL11,VARC=0000A021,VARI=00000708,VARO=0000A015;

is there any advice pls...

 

[rfpui]

Try VARC=00000021

----------------------------------
If anything can go wrong, it will.
(Murphy's Law)

 

[patcher]

Most probably you don't have clear signal on your line. Verify this one first using your voltmeter. If its okay you need to reprogram your data to allow clear signalling.

 

[trond345]

Thanks rfpui, patcher, after modifying varc=00000021, it works fine.