Relay help E/O port with doorstrike

[photon33]

I have a normally closed contact & a common coming from the security system to a magnetic door strike(24v).

I have the stereo jack wired w/bl to center(1) of jack(Relay1), w/gr to tip(2)(Relay 2) and bl/w gr/w to the shield(3).
When I connect to the n/c & common I am able to open & close the relay, however relaypulse will only work to close the connection.
If I set the relay to closed(the door locks), I cannot relaypulse to open.
If I set the relay to open(the door unlocks), I can relaypulse to lock for 5 seconds.

This is working on the current system.

The documentation from Avaya has no examples for me to look at, so maybe somebody here can help....

 

[psmit]

When you add an extra relay, you can reverse the pulse direction.
If necessary I can send you a diagram wich works perfectly with a normally closed circuit

 

[photon33]

Yes! Please send to
roguetel(at)gmail.com
Thanks

 

[jaze]

psmit - I have the exact same situation. I have a system tied to a closure system that is a normally closed circuit. Can you please send me the same diagram as well?? Is there a way to configure the IP Office system to be in a normally closed state as opposed to open? Any help would be appreciated. Please send to chawboy89@yahoo.com. Thank you!!!

 

[photon33]

jaze
The documentation at the time of this post
I never received the diagram, and investigation into the matter showed that the IPO will never operate as a normally closed system. Even if it did, it will always default to open on a reboot.

I contacted the security company who maintained their system to put a reversing closure behind the IPO.