Registering Crviewer.dll

[VBApprentice]

I successfully registered crviewer.dll with regsvr32 on my computer running the 2000 operating system. Registering the "same" dll on my computer running NT version 4.0 I get the following error:
DllRegisterServer in crviewer.dll failed
Return code was 0x80004002

I am at a loss to figure this out. I need to register this dll to run the Crystal reports in my application.

Any suggestion is very much appreciated.

Thanks in advance.

 

[Naith]

Check that your regional settings on NT are set to English.

Also, check that your comcat.dll file is the correct version by comparing the one on your client with the one on 2000.

Naith