REFTA DISPLAY

[melhabba]

good morning
I am soryy to ask you alot but I am new in Hipath4000
any one explain what mean error in refta display output

<DISPLAY-REFTA:TYPE=CIRCUIT,KIND=ALL;
DISPLAY-REFTA:TYPE=CIRCUIT,KIND=ALL;
H500: AMO REFTA STARTED
+-------------------------------------------------------------------------+
| R E F E R E N C E C L O C K C I R C U I T S |
+--------------+---------+----------+---+------+------+------+-----+------+
| PEN | MODULE | DEVICE |PRI|ERROR |BLOCK |SUPP. |READY|SRCGRP|
| | | | | | | |BUT | |
| | | | | | | |ASYN.| |
+--------------+---------+----------+---+------+------+------+-----+------+
| 1- 1- 25- 0 | DIUT2 | S2COD | 0| 65535| N | | N | 1|
| 1- 1- 25- 1 | DIUT2 | S2COD | 0| 65535| N | | N | 1|
| 1- 2- 25- 0 | DIUT2 | S2COD | 0| 65535| N | | N | 1|
| 1- 2- 25- 1 | DIUT2 | S2COD | 0| 65535| N | | N | 1|
| 1- 3- 25- 0 | DIUT2 | S2COD | 0| 48000| N | | N | 1|
| 1- 4- 25- 1 | DIUT2 | S2COD | 0| 32000| N | | N | 1|
| 1- 4- 25- 0 | DIUT2 | S2COD | 0| 14725| N | | N | 1|
| 1- 3- 25- 1 | DIUT2 | S2COD | 0| 14440| N | | N | 1|
+--------------+---------+----------+---+------+------+------+-----+------+

 

[sbcsu]

If the ISDN circuits have been disconnected you will see errors on those circuits.
The 65535 errors would normally mean that the circuit has been disconnected for a long time.
To clear the errors:
CHA-REFTA:CIRCUIT,0,,,0;

Then look at them again (DIS-REFTA After a while to see if the errors are still happening.

If a circuit is disconnected you should see that elsewhere
Example:
DIS-BUEND:,B;