Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

redirect from any answering position

Status
Not open for further replies.

dwaxton

Technical User
Sep 18, 2015
3
AT
Hi,

at alex I found this in DBC223:

30.3 To redirect from any answering position

If you are already in the room containing extension 1234 and are unable to return to your own room before moving to an another (third) room you can order a new answering position from extension 1234 or from the new answering position.
• Lift the handset (dial tone).
• Dial *21*own extension number*the extension number of the new answering position# (special dial tone).
• Replace the handset.

What is the right configuration (CDIV?) to allow this for a normal directory?

I would like to redirect a DECT directory to somewhere else from a normal DTS, which are both in the same hunting group. So the user is able to throw the DECT one easily out of the group and put it back into it by cancelling the diversion. They are at different locations.

Thanks for your help.

(MD110 BC12)
 
Hi

To set and unset internal follow me *21 and #21 on a dect from a digital extension, the digital must have CDIV dig 4+5=16 in the extension category. Then this should work - put DND on the DECT: INVOKE *21*dect*dect# - CANCEL #21*dect#

best parnum
 
Thanks, but I already tried this without luck. :(

<kscap:dir=xxxx;
KEY SYSTEM CATEGORY PRINT
DIR TRAF SERV CDIV ROC ITYPE TRM ADC LANG BSEC
xxxx 01060602 0003120100 001161000 000001 20 0 00000000000000 F 0

END
 
Hi,
If it do not work can you please post the "GESPP" of the DECT Extension.
In the CDIV-Parameter of the CSP on D2 and D3 must FME be allowed . (CDIV= x08xxxxxxxx)
best regards,
Norbert
 
Not working but when you see at the CDIV it should be allowed.

Code:
<gespp:csp=all;
COMMON SERVICE PROFILE
CSP  TRAF        SERV           CDIV      ROC     NPRES
0    0101060602  1010200000000  00810000  000001  0010

END
 
dwaxton,
Please stop using the "spoiler" tag. It is much more appropriate to use the "code" tag or [tt]monospace[/tt].

e.g.
Code:
<gespp:csp=all;
 COMMON SERVICE PROFILE
 CSP TRAF SERV CDIV ROC NPRES
 0 0101060602 1010200000000 00810000 000001 0010

 END
or monospace
[tt]
<gespp:csp=all;
COMMON SERVICE PROFILE
CSP TRAF SERV CDIV ROC NPRES
0 0101060602 1010200000000 00810000 000001 0010

END
[/tt]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top