Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recover Password and access Firebox II

Status
Not open for further replies.

vexxed

MIS
Nov 29, 2002
18
CA
Hi,

I have purchased an older Firebox II to learn about it and I cannot get into it. When I try and install the CD on my workstation it wants several serial numbers or keycodes which I do not have.
Is there a guide or a way to reset the device. Also where can I get software to access it, Watchguard won't help me without a fee.
I would appreciate any help.
thank you
 
You'll still need a software key for the firebox management, contact the person who sold it to you and they should be able to supply it.

To reset the password on the watchguard, connect a crossover cable to the trusted and external interfaces (i think, it might be optional and trusted) and boot it up. After a few minutes, the status lights will begin blinking regularly between the interfaces.

At this point the firebox is configured with a default IP of 192.168.253.1, password "wg" without the quotes. Configure your computer with the IP 192.168.253.2, connect the crossover cable from the trusted interface to your computer, and upload a new config.

You should then upload the config and it'll reboot
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top