Hello,
I have a Callmaster IV, and I would need to send the Audio to the PC, for recording.
At the moment I use a cable that on one side has a Jack of 6.35mm (1/4 inches) and on the other side has a Jack of 3.5mm (1/8 inches).
The 3.5mm Jack is connected to the microphone input of the PC, and the 6.35mm Jack is connected to one of the 6.35mm Jack input of the Callmaster. This solution usually works, but sometimes it seems that the 6.35 Jack doesn't perfectly fit inside of the Callmaster IV.
Do you know if there can be an alternative solution?
For example, I have seen that there is an RJ45 in the bottom of the Callmaster, with the symbol of a speaker. If I had a cable with a 3.5mm Jack on one side (for the PC) and an RJ45 on the other side, could it work?
Thank you very much,
Simone
I have a Callmaster IV, and I would need to send the Audio to the PC, for recording.
At the moment I use a cable that on one side has a Jack of 6.35mm (1/4 inches) and on the other side has a Jack of 3.5mm (1/8 inches).
The 3.5mm Jack is connected to the microphone input of the PC, and the 6.35mm Jack is connected to one of the 6.35mm Jack input of the Callmaster. This solution usually works, but sometimes it seems that the 6.35 Jack doesn't perfectly fit inside of the Callmaster IV.
Do you know if there can be an alternative solution?
For example, I have seen that there is an RJ45 in the bottom of the Callmaster, with the symbol of a speaker. If I had a cable with a 3.5mm Jack on one side (for the PC) and an RJ45 on the other side, could it work?
Thank you very much,
Simone