Reading Nortel 450 config file

[HungryHouse]

Anyone know how to convert a 450 config file to a text file of some sort? I know there is no ASCII config upload feature on a 450, however, anyone find a way to read a 450 config file through windows?
Your suggestions are appreciated.
Thanks, HH

 

[CiscoRC]

You can run the Capture Text, that will give you a config file on Text from the emulation program. I've tested it, sometimes it's ok but you could also try PUTTY, it's a freeware emulation program.

 

[anthonyanderberg]

HH, I once tried to figure this out on our 350s but gave up after a half hour of staring at config file hex dumps. What's your end goal once you'd have the text config?