RDC Export Button Not Functioning

[JohnEfford]

I am displaying a CR report version 8.5, in Visual Basic Version 6 using the report designer component. On the development machine when everything works fine, on the test machine the report displays fine but the export button is inactive. I can press the export button but no export dialog is display, o error messages are displayed either.

I have included the following DLLs on the install.

crxf_pdf.dll
crxf_rtf.dll
ExportModeller.dll
crtslv.dll

I know that the files are registered properly (I had to update the version of ATL.DLL on the target machine). I only want to export to PDF, RTF and word so I cannot see were I am going wrong.

 

[IdoMillet]

Did you enable the Export button in the CRViewer component (on the VB form)?

Cheers,
- Ido

CUT, Visual CUT, and DataLink Viewer:
view, e-mail, export, burst, distribute, and schedule Crystal Reports.

http://www.MilletSoftware.com

 

[SurfingGecko]

Don't forget to include and distribute the export drivers with your application. The export button will only be active and load if it detects drivers.



Cheers,

SurfingGecko

http://www.surfinggeckosoftware.com

 

[JohnEfford]

Hi

Ido: yes the export button is enabled.
SurfingGecko: I thoght, crxf_pdf.dll and crxf_rtf.dll were the export drivers that I needed.

Still struggling with this on any further suggestions appreciated.

Cheers.

 

[JohnEfford]

Problem sorted

SurfingGeko was correct I had not linked in the destination DLLs.

Cheers